[. . . ] The countertop must be bonded with heat resistant (212 °F / 100 °C) adhesive to prevent distortion or dissolving. The cooktops should only be installed as shown, while maintaining the required safety distances shown. Do not install the cooktop between two tall cabinets, this is a fire hazard. [. . . ] The included gas regulator/adapter combination must be installed between the cooktop and the gas shut off valve. If clearance for the regulator does not exist directly under the cooktop, it may be moved closer to the shut off valve. ^ Set the cooktop in the cut-out and center it. 7 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service. 8 Electrical connection This appliance must be grounded according to local or national codes. All electrical work should be performed by a qualified electrician in accordance with local codes and the: National Electrical Code ANSI / NFPA No. 70 for the USA This appliance is equipped with a three-prong grounding plug to prevent shock hazards. If the plug does not fit the outlet, have a proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1). , WARNING Disconnect the appliance from the main power supply before installation or service. To reduce the risk of electric shock, make sure the appliance is properly grounded after installation. Power supply The automatic ignition requires that the cooktop be connected to a 120 VAC, 60 Hz power supply. (1. 2 m) long power cord that is ready for connection to the appropriate outlet. Please place the power outlet so that it is accessible after the appliance has been installed in the countertop. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy, of an effective grounding system. Note to the installer Please leave these instructions with the consumer or the appliance. 9 Gas connection Installation and service must be performed by a qualified installer, service agency or the gas supplier. This appliance must be installed with its own shut off valve and the included gas pressure regulator. [. . . ] Do not use any regulator/adapter unless it has been supplied by Miele. If there is any doubt concerning installation contact the Miele Technical Service Department: U 1-800-999-1360 techserv@mieleusa. com V 1-800-565-6435 service@miele. ca After connecting the appliance check all fittings for gas leaks e. g. It will also have a sharp, blue inner core that will vary in length proportional to the burner size. [. . . ]